Publicité
2. With the robot switched off, submerge it in the pool and gently shake it a few times to facilitate discharge of air.
Excess air trapped in the body could result in erratic behavior of the swivel head ( i.e. spinning repeatedly in the
pool for a few minutes ).
Power indicator
light (Green)
3. Slide the power switch to "ON" ( while the robot is still submerged ) – the indicator light will turn on and activate the motor
automatically ( water level covering the sensors at the top of the swivel head ). Let the robot sink to the pool floor and observe
its first forward and reversed movements across the pool bottom. If it runs along the pool wall instead of perpendicularly,
retrieve it and redeploy it while making sure its front/back is facing the pool wall.
Power indicator light starts to blink when 10 minutes of usage remains.
Power indicator light :
No light - Power off / no power
Blinking light - Battery power will be exhausted within 10 minutes.
NOTE:
- Refrain from making any physical contact with both water sensors.
4. To retrieve the robot from the pool, attach the hook to a telescopic pole ( not provided ) and use it to retrieve the
float, if you are unable to retrieve with your hands.
( for EU & US only )
( for Australia / New
Zealand only )
As
soon as the robot reaches the water surface, locate the grip that is underneath the base and indicated with the hand
symbol ( see diagram below ) to facilitate retrieval from the pool. Make sure to always grip the robot from this end to prevent
debris from falling back into the pool during retrieval.
5. Slide the power switch OFF. Rinse the robot with fresh water after every use. DO NOT use any detergent.
6. Dry the charging port and pins thoroughly ( TIPS: Use cotton bud to dry them )
NOTE: To ensure the most efficient cleaning, when your pool is quite dirty, it is recommended to empty the debris compart-
ment after the first 30min of operation, or whenever the robot's movement has slowed down noticeably. Then return the robot
( with an emptied debris compartment ) to the pool, and let it run through the remaining of its cycle.
bwt.com
MAINTENANCE & CLEANING
Light - Power on
1.
1.
2.
2.
2.
1.
3.
3.
2021/10 : A
7/147
Publicité
