Publicité
HOW THE ROBOT WORKS
The robot has a water-propelling nozzle at the bottom of the swivel head. Water is first sucked in through the suction mouth
at the bottom of the robot, which then goes through the filter and is discharged via the propelling nozzle. Water jetting from the
nozzle propels the robot forward. Once the robot stops against an obstacle such as the pool wall, its side flap sways and its
swivel head turns 180˚, allowing the robot to move in the opposite direction. The robot moves in a generally straight pattern in
one direction and in an arc pattern in the other direction. The robot vacuums the pool bottom as it moves, collecting debris in
its compartment.
GETTING STARTED
Charging The Battery
IMPORTANT NOTE: Fully charge the robot ( about 6 hrs ) before using it for the first time.
WARNING!
• Use only the original external adaptor and charging plug provided.
• Make sure the robot and the charging port are clean and dry before set-up and charging.
( TIPS: Pry open the protective cover and use a cotton bud to dry the charging port and charging pins )
• The charging pins are waterproof. However, remnants of water in the port and around the pins
could result in natural occurrence of stains ( a byproduct of chemical reaction between water and
electric currents ). Otherwise, the stains can be removed by light scrubbing with a cotton bud
soaked with juice of lemon or vinegar.
• Make sure the robot is off by sliding the switch to the OFF position prior to charging.
1. Place the unit on a flat surface. Slide the switch to the OFF position.
2. Pry open the protective cap. Align and attach the charging plug to the charging port.
WARNING! Be sure not to invert the charging plug and ensure both the charging plug and charging
port are clean and dry before charging them. TIPS: Use cotton bud to dry the charging port and
pins. Plug the charging cable of the external adaptor into the charging plug.
bwt.com
MAINTENANCE & CLEANING
OFF
ON
2021/10 : A
3/147
Publicité
