Publicité
Locking Pin
The trajectory of the robot is dependent on the position of the pin that fixes the axle to a certain angle. There are two
pins: the one on the right is fixed and should remain untouched. Alter only the position of the pin on left.
Recommended settings:
NOTE: Wheel axle should be positioned
above the locking pin
Pin location
1
2
3
Pool Preparation
- If there are stones, roots or metal corrosion in contact with the underside of the liner, discard them prior to using the robot.
If necessary, seek assistance from a qualified professional.
- If the liner is brittle, damaged or wrinkled, contact a qualified professional to perform the necessary repairs or perform a liner
replacement prior to using the robot.
- Remove any pool ladder, surface skimmer, and other floating objects from the pool as they may obstruct the movement of
the robot's float and, consequently, the movement of the robot also.
- If you are using a saltwater pool, make sure all salt are dissolved before placing the robot into the water.
IMPORTANT NOTE: Turn off the filtration system ( as instructed in your filtration manual ) at least 15 minutes prior to
deploying the robot.
bwt.com
MAINTENANCE & CLEANING
1
2
3
Pool size
For pools where the shortest
length is 3 meters or above.
If the robot does not cover the
entire pool with either pin
position 1 or 3, try below setting.
If the situation persists, deploy
the robot from a di erent location.
For pools where the shortest
length is 3 meters or below.
( Factory setting )
2021/10 : A
5/147
Publicité
