Publicité
EN
-
Lower the selector (5) to release the battery (6).
-
It is possible to leave the battery in the
machine or to remove it, if needed.
-
Insert the plug (27) in the battery (6), then
connect it to the battery charger (21) at
an AC power outlet.
Warning
WARNING:
Check that the mains voltage is compatible
with the operating voltage of the battery charger.
-
Charge the battery until the "Green" LED
(28) turns on, then unplug the power supply
cord (29) from the AC power outlet
and the cord (27) from the battery.
NOTE:
For the full recharge of the battery, 2 hours
are necessary for the 10 A battery and 4
hours for the 20 A battery.
Partial recharges are also possible.
5.1.a - Battery charge from a 12V
socket (Fig. 4a - 9)
-
Place the machine in the vehicle or van
trunk.
-
Lower the selector (5) in order to release
the battery (6).
-
It is possible to leave the battery in the
machine or to remove it if needed.
-
Insert the plug (27a Fig. 4a) in the battery
(6), then connect it to the battery charger
(35) at a 12V power outlet of the vehicle or van.
Warning
WARNING:
The machine is fi tted with a safety device
which prevents its operation with an open
battery compartment.
6.1 CONTROL PANNEL
(Fig. 10)
30) Start-up button
-
If pressed for three seconds it actuates
the circuits; the LED (31) turns on indicating
the inserted line, the vacuum cleaner
operation LED (32) turns on, the water
supply LED (33a) turns on and one of the
battery status LED (34) turns on.
NOTE:
After 5 minutes that the machine is idle automatically
turns off and it is necessary to repress the button
(30) to restart it.
20
36) Water supply button
-
If this button is pressed, the quantity of
water to be supplied during the cycle until
the end of the supply can be set up, by
passing from one quantity to another, the
quantity is indicated by one of the LEDs
(33);
Led 33a = minimum supply.
Led 33b = average supply.
Led 33c = maximum supply.
Leds 33 turned off = no supply.
NOTE:
The rotation of the brush is enabled by the levers
(4) pressed or by the lever (3) pressed.
It is possible to cut off the water supply by
pressing the button (36) until all LEDs (33)
are turned off .
37) Vacuum cleaner button.
-
Upon the start-up of the machine, the vacuum
cleaner is set to standard operation
and the LED (32) turns on.
-
It is possible to go from a normal operation
to a silent operation until the vacuum
cleaner is turned off by pressing the button(37).
The lit LED (32) indicates a normal operation.
The lit LED (38) indicates a silent operation.
The turned off LEDs (32) and (38) indicate
the turned off vacuum cleaner.
NOTE:
The vacuum cleaner will operate for another
10 seconds before turning off when switched
from silent operation to off .
NOTE:
The operation of the vacuum cleaner is enabled
by the levers (4) pressed or by the lever (3) pressed.
39) Led indicating the maximum level of
the recovery water
-
It turns on when the level of water from
the recovery tank has reached the maximum
level; when reaching the maximum
l
evel, the turned on LED (39) means that
the machine turns off .
34) Battery charge status LEDs
-
The LEDs (34) indicate the battery charge
status.
Led 34a = low battery.
Led 34b = low battery, please recharge
the battery.
Led 34c = battery full.
-
When the battery is low, the yellow LED
Publicité
