Télécharger Imprimer la page

Mafell MF 26 cc Traduction De La Notice D'emploi Originale page 32

Publicité

7
Troubleshooting
Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Machine cannot be switched on
Machine stops while cutting is in
process
Tool jams when advancing the
machine
Burn marks on the cut surfaces
Chip ejection blocked
Danger
Determining the causes for existing defects and eliminating these always requires
increased attention and caution. Pull the mains plug beforehand!
Cause
No mains voltage
Mains fuse defective
Carbon brushes worn
Mains failure
Machine overloaded
Feed rate too fast
Blunt tool
Tension in the workpiece
Poor machine guidance
Uneven workpiece surface
Tool unsuitable or too blunt for
the work process
Wood is too damp
Extended operation without
extraction
Elimination
Check power supply
Replace fuse
Take the machine to a MAFELL
customer service shop
Check mains back-up fuses
Reduce feed speed
Reduce feed speed
Release the switch immediately.
Remove machine from the
workpiece and exchange tool
Use parallel stop
Straighten the surface
Replace tool
Clean chip ejection
Connect to an external extraction,
e.g. portable dust extractor
-32-

Publicité

loading