Publicité
1 hose connector
1 chip deflector (only for model MAX aluminium)
1 guide rail (for models 917804, 917880, 917881, 917883, 917885)
1 carrying case (for models 917801, 917820, 917823, 917825, 917802, 917840, 917843, 917845)
1 transport case (for models 917804, 917880, 917881, 917882, 917883, 917885, 917888)
1 operating manual
1 folder "Safety instructions"
2.6 Safety devices
Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative.
Before operating the machine,
check the safety devices for
function and possible damage. Do
not use the machine with missing
or ineffective safety devices.
The machine is equipped with the following safety
devices:
- Upper stationary saw guard
- Lower retractable saw guard
- Large base plate
- Handles
- Index mechanism and brake
- Hose connector
2.7 Use according to intended purpose
The groove-cutting machine is exclusively suited for
longitudinal and cross cutting as well as for milling solid
wood, panel materials such as chip board, coreboard,
MDF board, gypsum plasterboard, aluminium
compound panels and laminate panels.
Special use of the tools:
- The saw blade is exclusively suited for processing
wood, plaster board panels, aluminium compound
and laminate panels.
- The slitting unit (special accessories) is exclusively
suited for processing wood and plaster board
panels.
- The adjustable groove cutter is exclusively suited
for machining wood.
- The plasterboard milling cutter is exclusively suited
for processing wood and plaster board panels.
- The aluminium compound milling cutter is
exclusively suited for machining aluminium
compound panels.
Only use the approved tools. Our tools are
manufactured according to EN 847-1. Any other use
than described above is not permissible. The
manufacturer cannot be held liable for any damage
arising from such other use.
To use the machine as intended, comply with the
operating, maintenance and servicing conditions
prescribed by Mafell.
2.8 Residual risks
Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use that can lead
to health consequences will always
remain.
- Touching the part of the saw blade that protrudes
below the workpiece when cutting.
- Touching of turning parts from the side: Tool,
clamping flange and flange screw.
- Machine backlash if the blade gets stuck in the
workpiece.
- Breakage and hurling out of the tool or parts of the
tool.
- Touching live parts with the housing open and the
mains plug not removed.
- Hearing can be impaired when working for long
periods without ear protectors.
- Emission of hazardous dusts during longer lasting
operation without extraction.
-24-
Publicité
