Publicité
31 Fitting the jack slat.
A
Towards the façade
B
Attach the two slats to the BSO4902.
DIN7991M8x35mm
32 Preparing the cylinder in manual mode.
Note :
Double-span and multiple-span pergola: carry out this
operation for the first span.
A
Raise the jack manually.
B
Retract the piston rod as far as it will go.
PLB11246
Stop nut + M8 washer
Check the 4mm dimension after pressing UP twice. Do not unscrew the cylinder rod.
Note :
carry out this operation for the first span.
Axle-less slats.
C Move back into position.
D
Fit all the slats in the span. Refer to
paragraph 18 on page 15.
Be sure to follow the order of operations A, B and C.
respect the 4mm dimension may result in
C Pull out the 4 mm piston rod.
IMPORTANT,
Double-span and multiple-span pergola:
Towards the façade
!
ATTENTION,
Opération importante à respecter scru-
puThis is essential to ensure that your
pergola operates correctly. Failure to
damage to the jacks.
!
!
P. 25
Publicité
