Publicité
27 Wiring.
AUTOMOBSOVERCLIM : see page 35.
10A circuit breaker. not supplied
Panel
Differential
electrical
30mA
not sup-
not sup-
plied
plied
DEDICATED LINE
Install the control unit and transformer in the
Cover Profile.
Note :
Only the Blue and Brown cables are required to wire the actuator. You can cut and insulate the Red Yellow
Green and Black cables.
Power supply
230V - 50Hz
3 Cables
- 1 cylinder for a single span. Programming Cylinders in single mode.
IMPORTANT,
Make a seal at each cable
entry to the automated sys-
tem.
TRANSFO
Raising the transformer
IMPORTANT,
- Position the transformer at least 400mm from the operator.
- Remove the antenna from the operator.
- Raise the transformer.
- Earth the transformer on the 230V AC side.
400mm Minimum
230V
Once the transformer is powered up, disconnect it if necessary on the 230V
!
24 VDc
2 Cables
To ensure optimum syn-
chronisation of the two
cylinders, make sure that
the two connection cables to
the control unit are the same
ATTENTION,
side.
Antenna tip
For better dialogue, remove the
antenna from the control unit. Seal
the cable outlet.
-
+
IMPORTANT,
length.
24V
P. 21
Publicité
