Publicité
21 Floor-mounted.
Fix the mounting plates to each concrete block made beforehand using a minimum of two screws.
Our recommendation: Ø8mm or Ø10mm concrete screws, minimum length 120mm. Pull-out strength 500DaN (500Kg)
For installation using a chemical sealant kit, refer to the instructions for use for the product used.
Make sure that the mounting plates are firmly attached to the floor. Risk of falling.
22 Fitting the cover profile.
Insert the seal tab.
A Position
Overlap on the first slat
Install the covering profile on the joint of the left
and right slat support rafters.
C
Install the actuator and IP54 junction box in the
cover profile.
ATTENTION,
B Fix to each rafter.
DIN7982ST4.2x16mm
Note :
double-span and multi-span
pergolas, carry out these operations
for each span.
PBSO4003
Fixing at the joint of the rafter
supporting the slats.
P. 17
Publicité
