shark S-DRAK 2 Manuel D'utilisation page 10

TEXTILE PARTS
A
C
REPLACING THE INTERIOR
- Start the operation by sliding the plastic
tabs of the front of the head section in its
housing beginning with one side (Fig. A).
- Insert one end of the neck pad at the edge
of the helmet, and feed the remainder of the
neck pad beneath the edge of the helmet.
Insert the other edge of the neck pad at the
other edge of the helmet (Fig. B).
- Then, hook the Velcro bands (Fig. C-D).
10
B
D
WARNING! The polystyrene lining and
interior padding are critical to properly
fit your helmet on your head. An improper
fit could cause your helmet to become
dislodged in an accident, leaving your head
unprotected and resulting in severe head
injury or death. If you are not sure that you
properly replaced the comfort padding, DO
NOT USE YOUR HELMET. Contact your retai-
ler for assistance or advise.