The Remote Control (Optional) - Viscount Prestige 50 Guide Rapide

Viscount Prestige 50

2.7 THE REMOTE CONTROL (OPTIONAL)

The Prestige 50 can be equipped with a radio remote
control which can be used to control the general
volume of the organ and the main sequencer functions
at a distance. Refer to your dealer to purchase this
device.
The button functions are:
1. [PLAY-STOP]: press repeatedly to start / stop
recording / playback the MIDI sequence.
2. [PAUSE]: stops the MIDI sequence temporarily
during playback.
3. [AUTO PLAY SONG]: these six buttons can be used to playback automatically the first six
MIDI backing tracks saved on the floppy disk, without the need to press the [PLAY-STOP]
button to start playback.
4. [SONG]: these two buttons can be used to select the MIDI sequences on the floppy disk.
5. [VOLUME]: buttons for adjusting the general volume of the organ.
NOTE
The Led on the [PLAY –STOP] switch indicates the datas transmission of the remote control.
In case of flashing, please replace the batteries located inside the remote control.
REPLACEMENT OF THE BATTERIES
Remove the screw located on the back of the remote control, carefully remove the plastic cover and
replace the batteries in the proper place (Do not invert the polarity – see picture below)
ATTENTION – use only CR1220 3 Volts Lithium batteries
3V lithium
battery
positive pole (+) above,
negative pole (-) below
- Quick Guide
3V lithium
battery
1
2
3
36
5
4
cover's lock screw