Operations On The Central Control Unit; Characteristics Of The Control Unit; Regulating The Volumes - Viscount Prestige VIII - IX Mode D'emploi

3. OPERATIONS ON THE CENTRAL CONTROL UNIT

3.1 CHARACTERISTICS OF THE CONTROL UNIT

The Prestige organ central control unit is located in a flush-fitting box underneath the first manual on the right.
Inside, this flush-fitting box is divided into two parts. The upper part (with an alphanumeric display of 2 x 40 characters) is
dedicated to control of the general functions of the instrument, while the lower section (with 3-digit numerical display)
controls the floppy disk drive.
Alphanumeric display
ENCODER
3 digit display
When the organ is switched on, the alphanumeric display shows:
And then:
L    L
#23. ," *- "',% -0% , 4-'!#1 . 0 +#2#0
During display of this message, the Prestige carries out self-testing procedures and pre-sets for operation.
If there is no disk in the floppy disk drive, three horizontal dashes appear on the 3 digit display (in the floppy disk drive
control section).

3.2 REGULATING THE VOLUMES

When the self-testing and set-up procedures are complete, the alphanumeric display shows the video page used for
regulating the volume levels. The Prestige allows both general regulation of the instrument volume (MASTER parameter)
and adjustment of the volume of each individual manual.
The display will be as shown below:
 
?=
Viscount PRESTIGE VIII - IX
      
    
#" *
<;M<;
   
 ,
<;M<;

35
Section for control of
general functions
Section for control of the
floppy disk drive and
sequencer
 ,
<;M<;