2.3 THE CONTROLS FOR THE MANUAL THUMB PISTONS
S
Prestige 50
1
1. [S] button: "Set" button which enables memory saving. To save a memory, simply press the
[S] button and, keeping it pressed down, then press the button of the memory you wish to save.
2. Memories: this section contains the instrument's general memories.
The memories also include an [HR] button, also known as 0, which recalls the set up that was
present before a memory was activated. The contents of [HR] are not affected by calling up a
memory when another one has previously been activated.
In each memory the following can be saved
-
the voices (including Orchestra)
-
the couplers
-
the Tremulants (also with different speed and depth by activating this function on
Menu Set-Up, see par. 4.3)
-
the MIDI To controls (par.3) and Program Change set using the SEND PROGRAM
CHANGE function ("Advanced Manual")
-
the Enclosed and Automatic Pedal (by activating the relevant function, see par. 4.3)
3. [ENC] button: pressing this button activates the Enclosed function used to control the organ's
general volume by means of the [MAN.II] pedal.
4. [A.P.] button: this button enables the Automatic Pedal, used to play the voices of the pedal
board using the first 32 notes of Man.I. In this case, the organ pedal board is deactivated and the
voices become monophonic, with priority given to the lowest note.
5. [T] button: "Tutti" button, which turns on a preset series of voices and couplers.
The voice composition of the 'Tutti' function is programmable. To save a new set up, switch on
the voices and couplers of your choice, press [S] and, keeping it pressed down, then press
button [T] or the [TUTTI] foot piston.
6. [C] button: "Cancel" button, which switches off any voices, couplers and buttons on the manual
divisionals which may be on and turns the HR buttons on.
7. Floppy disk drive: use only 720 Kb or 1.44 Mb 3.5" floppy disks.
Quick Guide - Viscount Prestige 50
viscount
HR
1
2
3
4
5
6
2
31
7
ENC
A.P
T
C
3
4
5
6