Bartscher 70 Série Mode D'emploi page 45

Safety cock
To substitute the cock, it is necessary to remove the knobs and the control panel, then unscrew in
sequence the pipe union of the piping which goes to the burner, the pipe union of the piping of the
pilot burner, the thermocouple and finally, the pipe union of the ramp. Then substitute the part.
Thermocouple
To substitute the thermocouple of the pasta cooker, remove the knobs and take off the control panel.
It is then necessary to unscrew the fitting of the thermocouple on the cock and the one on the pilot
unit, then substitute the part.
Elements (fig.22 pag.7)
To substitute the elements, it is necessary to open the door of the compartment. Remove the
protector (1) from the elements by loosening the fixing screws (2); unscrew the fixing screws (3) of
the element to be substituted and, after disconnecting, remove it.
Electric components of the electric pasta cooker (fig. 23, pag. 7)
For the replacement of the selector (5), of the contactor (4), of the lamp, and of the main terminal
board (2) of the electric pasta cooker, it is necessary to unscrew the fixing screws of the control
board (1), remove it, then disconnect the electric cables of the component and replace it. After the
replacement, connect the electric cables following the instructions of the wiring diagram.
WHEN SUBSTITUTING, ONLY ORIGINAL SPARE PARTS SUPPLIED BY THE
MANUFACTURER MUST BE USED. THE OPERATION MUST BE CARRIED OUT BY
AUTHORIZED PERSONNEL.
ATTENTION! In the event that components of the gas installation are substituted, it is
necessary to check for tightness and the correct functioning of the various parts.
THE MANUFACTURER RESERVES THE RIGHT TO WITHOUT NOTICE MODIFY
THE FEATURES OF THE APPLIANCES DESCRIBED IN THIS MANUAL.
Pág. 44/69