Publicité
DIVA UTOPIA
U s e r m a n u a l
Features of the DIVA UTOPIA rear panel
DIVA UTOPIA Primary loudspeaker (fig. 17)
• Mains connector — for connecting to the mains.
Note: DIVA UTOPIA loudspeakers are supplied with an appropriate mains cable for the countries in which they are marketed.
• A USB socket for the connection of USB memory hardware.
• A wired network socket — for connecting to your network via an RJ45 cable.
• A TosLink optical digital audio socket — for connecting external digital audio sources.
• HDMI eARC CEC input — for connecting an external audio-visual device via an HDMI eARC CEC cable.
• RCA analogue inputs — for connecting an analogue source.
• Ground switch — select the default position unless the product is connected to a high-fidelity system (via an analogue
audio connection that includes a ground connection) that includes another grounded source component or if hum is audible
through the speakers.
• A wireless pairing button — for connecting the Primary loudspeaker and the Secondary loudspeaker wirelessly using UWB
technology. and to wake up the speaker from a deep sleep standby.
• A Primary and Secondary loudspeaker connection socket — for linking the Primary and Secondary loudspeaker using the
supplied RJ45 cable.
• A service port — for service connection (factory use only).
• A voltage switch — for selecting the input voltage of the power supply as 110V or 230V (factory use only).
• A pinhole for Wi-Fi configuration and reset — to learn more about Wi-Fi configuration and restoring the DIVA UTOPIA to
factory settings, refer to the "Wifi reset and Factory reset" section.
Secondary DIVA UTOPIA loudspeaker (fig. 18)
• Mains connector — for connecting to the mains.
• A service port— for service connection (factory use only).
• A wireless pairing button— for connecting the Primary loudspeaker and the Secondary loudspeaker wirelessly and to wake
up the speaker from a deep sleep standby.
• A Secondary and Primary loudspeaker connection socket— for linking the Primary and Secondary loudspeaker using the
supplied RJ45 cable.
• A voltage switch— for selecting the input voltage of the power supply as 110V or 230V (factory use only).
• A pinhole for reset — to learn more about restoring the DIVA UTOPIA to factory settings, refer to the "Wifi reset and Factory
reset" section.
Multicoloured status indicator "Primary network status LED" (fig. 17, 18)
1. No LED — Device is off or in sleep mode.
2. White LED — Network connection successful.
3. Orange LED — Startup, network boot or factory reset.
4. Flashing orange LED — Connecting to network.
5. Purple LED — Wireless connection configured but network not found.
6. Purple flashing LED — Wireless setup mode
7. Blue LED — Firmware update underway or DIVA UTOPIA in recovery mode.
8. Red LED — System error.
Multicoloured status indicator "Speaker Pairing" (fig. 17, 18)
1. No LED — No devices paired.
2. White LED — Speaker pairing successful.
3. Flashing purple LED — Pairing mode.
4. Flashing green LED — ZigBee remote control pairing mode.
5. Purple LED — Pairing successful but product disconnected (Secondary off).
6. Orange LED — The Secondary loudspeaker is not paired.
7. Red LED — System error.
Pairing the Primary and Secondary loudspeakers (fig. 17, 18)
DIVA UTOPIA loudspeakers are paired in our manufacturing workshops. Two paired loudspeakers
can be identified by the packaging box and the serial numbers indicated on it.
Example:
30
30
Publicité
