Publicité
3.2 ADVANCED PROGRAMMING
Display
Advanced Function
REVERSE STROKE WHEN OPENING
rS
CLOSING
Od
LEAF OPENING DELAY (only displayed with the
r1
LEAF 1
DECELERATION:
The deceleration space can be adjusted as a percentage of the total travel of leaf 1.
Adjustable from
00
= no deceleration
01
= minimum deceleration space
99
= maximum deceleration space
r2
LEAF 2 DECELERATION (only displayed with the
The deceleration space can be adjusted as a percentage of the total travel of leaf 2.
Adjustable from
00
= no deceleration
01
= minimum deceleration space
99
= maximum deceleration space
PF
PRE-FLASHING
EC
ANTI-CRUSHING SENSITIVITY (only displayed with the
Varying this function alters the time after which the board commands the
leaves to reverse their direction in case of an obstacle or to stop if they are
in the mechanical stop space (refer to the
The fourth consecutive obstacle detected in the same direction and position
will be defined as a mechanical stop and the leaf will stop in this position.
00
= minimum sensitivity (maximum time before reversal)
10
= maximum sensitivity (minimum time before reversal)
r8
MECHANICAL STOP SEARCH ANGLE (only displayed with the
Y
function):
The mechanical stop search angle within which the board stops the movement
without reversing if an obstacle is encountered or the mechanical stop itself
can be adjusted.
Adjustable in two modes:
01
= Mechanical stop search angle: approx. 1 degree
02
= Mechanical stop search angle: approx. 4 degrees
STATUS OF THE AUTOMATED SYSTEM:
St
ST
refer to
E045
00
99
to
%, in 1% steps.
00
99
to
%, in 1% steps.
Basic Function
and FLUID HAMMER WHEN
Mn
=
Mn
=
En
rB
function).
7
Default
no
2
function)
20
2
20
function):
no
Y
05
=
function):
En
02
=
732785 - Rev.D
Y
Y
Publicité
