Publicité
Display
Basic Function
Opening
and closing
photocells:
ON = registered
and committed
M2
MOTOR 2 dead-man DRIVE mode (only displayed with the
function):
+/R1
OPENS (displaying
-/R2
CLOSES (displaying
M1
MOTOR 1 dead-man DRIVE mode:
+/R1
OPENS (displaying
-/R2
CLOSES (displaying
tL
WORK TIME LEARNING OPERATIONS (SET UP):
Refer to the relative paragraph.
St
STATUS OF THE AUTOMATED SYSTEM:
1. set the selection:
Y
to SAVE and EXIT programming
no
to EXIT programming WITHOUT SAVING
2. press F to confirm; when completed, the status of the automated system
will appear on the display once again:
00
= CLOSED
01
= OPEN
02
= Stationary and then "OPENS"
03
= Stationary and then "CLOSES"
04
= In "PAUSE"
05
= Opening
E045
Opening and
closing photocells: ON = registered and committed
Closing photocells:
ON = registered and committed
oP
) for as long as the button is pressed
cL
) for as long as the button is pressed
oP
) for as long as the button is pressed
cL
) for as long as the button is pressed
Encoder 1: ON = connected and
registered correctly
BUS Status:
always ON
Encoder 2: ON =
connected and registered
OPEN Photocell:
ON = registered and committed
06
= Closing
07
= FAIL SAFE in progress
08
= Verifying
BUS-2EASY
09
= Pre-flashes and then "OPENS"
10
= Pre-flashes and then "CLOSES"
6
Default
correctly
Mn
2
--
=
--
--
Y
devices
732785 - Rev.D
Publicité
