Horizon Hobby UTB18 CAPRA Manuel D'utilisation page 25

EN
INSTALL THE TRANSMITTER BATTERIES
This transmitter requires 4 AA batteries.
1. Remove the battery cover from the transmitter.
2. Install the included AA batteries as shown.
3. Install the battery cover.
CAUTION: NEVER remove the transmitter batteries while the
model is powered on. Loss of model control, damage, or injury
may occur.
CAUTION: If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable batteries
may cause the batteries to burst, resulting in injury to persons and/or
damage to property.
CAUTION: Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to national regulations.
TRANSMITTER FUNCTIONS
8
7
6
CHARGING THE BATTERY
CAUTION: Only use chargers specifically designed to
charge the included Li-Po battery. Failure to do so could result
in fire, causing injury or property damage.
CAUTION: Never exceed the recommended charge rate.
NOTICE: Charge only batteries that are cool to the touch and are
not damaged. Inspect the battery to make sure it is not damaged
e.g., swollen, bent, broken or punctured.
Use only the included USB charger to charge the battery.
1. Connect the included USB-C power cable to the charger.
The charger will work with most 5V mobile power sources or
smartphone chargers with at least 1 amp of power output.
NOTICE: Charging the battery with a USB power port with less than
1 amp of power output can produce heat.
2. Connect the IC2 connector on the battery to the charger, noting
correct polarity. Charging a fully discharged battery takes
approximately 45–60 minutes. Charge times may vary depending
on the power source.
1
2
5
3
4
www.modellmarkt24.ch
1. Steering Wheel Controls direction (left/right) of the model
2. Throttle Trigger Controls speed and direction (forward/brake/
reverse) of the model
3. Power Button Turns the power on/off
4. Steering (ST-R) Servo Reversing Reverses the steering channel
5. Throttle Limit Limits throttle output to 50/75/100%
Select 50% or 75% for less experienced drivers or when you are
driving the vehicle in a small area
6. Indicator Lights
Solid red light—Indicates radio connectivity and adequate
battery power
Flashing red light—Indicates the battery voltage is critically
low. Replace the batteries
7. Steering Rate Adjusts the steering end points
8. Steering Trim Adjusts the steering center point
3. Disconnect the battery from the charger when the charging cycle
is complete.
4. Disconnect the power supply from the charger.
CAUTION: Once charging is complete, immediately remove
the battery. Never leave a battery connected to the charger.
CHARGER LED INDICATIONS
GREEN, flashing = Charging
RED/GREEN, flashing = Charger ready; standby
GREEN, solid = Charging complete
RED, solid = Charging error
6