Remote Master Mode Settings - Metz mecablitz 64 AF-1 digital Mode D'emploi

10.1 Remote master mode settings

The slave groups RMT and RMT2 are activated
at the factory.
The master flash unit (CTRL) and the slave
groups RMT and RMT2 can be activated or
deactivated!
If the master flash (CTRL) unit is deactivated,
it only controls the slave units and does not
contribute to exposing the shot.
10.1.1 Remote master mode settings
• Switch on the flash unit with the
TTL
• Press the sensor button of the displayed
0.6- 7.2 m
M-
m
35
Zoom
m
EV
• Press the
k
O
MODE
• Press the
STROBO
REMOTE MASTER
REMOTE SLAVE
Remote master mode CTRL+ is shown in the
p
picture. The master (CTRL) contributes in the
q
same light conditions to exposure at the sla-
ve flash groups (RMT).
TTL
REMOTE
CTRL
CTRL RMT
Light conditions can be assigned to master
(CTRL) and slave flash group RMT or slave
4 8
flash group RMT2 (see 10.1.4).
RATIO
182
button.
The start screen appears.
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
sensor buttons on the
REMOTE MASTER
touch display and select
REMOTE MASTER
sensor button on
the touch display.
Remote master mode is set.
PARAMETER
PARAMETER O
RATIO
CONTROL
p
q
CTRL/CTRL+ O
CTRL
CTRL+
.
TTL
REMOTE
CTRL+
CTRL RMT RMT2
4 8 1
RATIO
+
Switch from CTRL to CTRL+
D
• Press the button as often as it takes
for the selection menu to appear.
PARAMETER
• Press the sensor button on the
touch display.
• Press the sensor buttons on the
CONTROL
touch display and select
CONTROL
• Press the sensor button on the
touch display.
• Press the sensor button on the touch
display for the desired mode of operation
CTRL CTRL+
or alternatively .
The setting will take effect immediately
Light condition control (ratio) is only possi-
ble in CTRL+ mode.
.