Metz mecablitz 64 AF-1 digital Mode D'emploi page 180

Setting procedure
• Press the
• Press the
PARAMETER
PARAMETER O
• Press the
P/EV
ZOOM
• Press the
F
p
q
O
ZOOM
• Press the
70
85
• Press the sensor button on the touch
105
k
p
q
The following zoom positions are possible for
the reflector: 24 - 28 - 35 - 50 - 70 - 85 - 105-
135-180-200 mm (35 mm format).
Tip:
If you do not necessarily need the full guide
number and maximum flash range of the
flash unit, you can leave the zoom reflector at
the position for the shortest focal length of
the zoom lens.
This will provide full light coverage of the pic-
ture and eliminate the need to continually
adjust it to the focal length of the lens.
180
D
button as often as it takes
for the selection menu to appear.
PARAMETER
sensor button on the
touch display.
sensor buttons on the
ZOOM
touch display and select
ZOOM
sensor button on the
touch display.
sensor buttons on the
touch display and select the desired zoom
value.
display for the desired zoom value
The setting will take effect immediately.
.
PARAMETER
PARAMETER O
P/EV
ZOOM
F
q
ZOOM
AUTOZOOM
24
q
Example:
You use a zoom lens with a focal length range
of 35 mm to 105 mm. In this case, you set
the position of the reflector of the flash unit
to 35 mm.
Resetting to auto-zoom
• Touch the shutter release to begin a data
transfer between the flash unit and the
camera.
D
• Press the button as often as it takes
for the selection menu to appear.
PARAMETER
• Press the
touch display.
• Press the sensor buttons on the
touch display and select
p
ZOOM
• Press the sensor button on the
touch display.
O
• Press the sensor buttons on the touch
AUTOZOOM
display and select
AUTOZOOM
• Press the
touch display.
p
After around 10 seconds, the operation
display appears, or press the
repeatedly until the operation display
appears.
sensor button on the
ZOOM
.
.
sensor button on the
D
button