Publicité
Accessories
New Construction Accessories
WALL SLEEVE Galvanized zinc coated steel is prepared in an 11-step process,
PDXWSA
then powder coated with a polyester finish and cured in an oven for exceptional
durability. The wall sleeve is insulated for sound absorption and thermal ef-
ficiency, 16" High x 42" Wide x 13 3/4" Deep.
DEEP WALL SLEEVE EXTENSION For use when the wall is thicker than 13
PDXWSEXT
1/4"deep. The wall sleeve may be special ordered through your Sales Represen-
tative and will be cut to your specific depth requirements..
GRILLE Standard, stamped aluminium, anodized to resist chalking and oxidation.
PXGA
ARCHITECTURAL GRILLES Consist of heavy-gauge 6063-T5 aluminum alloy:
PXAA
PXAA – Clear, extruded aluminum
PXBG
PXBG – Beige acrylic enamel
PXSC
PXSC – Also available in custom colors.
CONDENSATE DRAIN KIT Attaches to the bottom of the wall sleeve for internal
PXDR10
draining of condensate or to the rear wall sleeve flange for external draining.
Recommended on all units to remove excess condensate. Packaged in quantities
of ten.
DECORATIVE SUBBASE Provides unit support for walls less than six inches
PXSBA
thick. Includes leveling legs, side filler panels and mounting brackets for electri-
cal accessories. Accepts circuit breaker, power disconnect switch, or conduit kit.
ELECTRICAL SUBBASE Provides unit support for walls less than six inches
thick. Includes leveling legs, side filler panels, mounting brackets, a plug-in recep-
tacle and field-wiring access. The subbase also includes electrical knockouts for
a power disconnect switch or circiut breaker.
PXSB23020 - Electrical Subbase - 230V 15 & 20A
PXSB23030 - Electrical Subbase - 230V 30A
PXSB26515 - Electrical Subbase - 265V 15A
PXSB26520 - Electrical Subbase - 265V 20A
PXSB26530 - Electrical Subbase - 265V 30A
REMOTE THERMOSTAT ESCUTCHEON KIT This kit contains ten escutcheons
PDXRTA
that can be placed over the factory control buttons when a remote wall mounted
thermostat is used. The escutcheon directs the guest to the wall thermostat for
operation and retains the LED window to display error codes and diagnostic
information.
SLEEVE EXTENSION RETROFIT KIT Galvanized zinc coated steel, 2.4" sleeve
PXSE
extension attached to the room side of the sleeve to allow for the installation of a
PD-Series Friedrich PTAC in a T-Series sleeve.
CONDUIT KIT WITH JUNCTION BOX Hard wire conduit kit with junction box for
PXCJA
208/230V and 265V units (subbase not required). Kit includes a means of quick
disconnect for easy removal of the chassis. *Required for 265V installations.
30
FRP029
Publicité
