Publicité
Troubleshooting
When operating with different protocols you may have
problems in each mode at the same time. – We recommend
reducing the number of protocols. Deactivate protocols
in the locomotive decoder that are not needed and also
deactivate if possible protocols in the central controller that
are not needed.
The locomotive jerks and falters – Check the CV setting for
motor variations, change if necessary, or carry out a reset to
the factory settings.
The locomotive does not run in analog. – The automatic
analog recognition is deactivated and must be activated
again (see CV table).
The locomotive (decoder) does not react. – Check the wiring
and the solder joints, redo if necessary. Check the connec-
tor for the decoder to make sure it has permanent contact
and check the way it was installed.
mfx/DCC operation: Locomotives standing on the layout start
running suddenly during mfx registration. – Deactivate the
automatic analog recognition on these locomotives.
The locomotive does not run. – The function "open doors /
close doors" is still active. Turn off the function "close doo-
rs"; after the sound ends the locomotive will run according
to the ABV that has been set.
50
Disposing
Notes on environmental protection: Products
marked with a trash container with a line
through it may not be disposed of at the end of
their useful life in the normal household trash.
They must be taken to a collection point for the
recycling of electrical and electronic devices.
There is a symbol on the product, the operating
instructions, or the packaging to this effect. The
materials in these items can be used again according to this
marking. By reusing old devices, materially recycling, or
recycling in some other form of old devices such as these
you make an important contribution to the protection of our
environment. Please ask your city, town, community, or
county authorities for the location of the appropriate
disposal site.
Warranty
The warranty card included with this product specifies the
warranty conditions.
• Please contact your authorized Märklin dealer for repairs
or contact:
U.S. only:
The USA subsidiary
using the contact form
at www.marklin.com.
GB only
Gebr. Märklin & Cie. GmbH
Reparaturservice
Stuttgarter Str. 55 - 57
73033 Göppingen
Deutschland
Tel: +49 7161 608 222
E-Mail: Service@maerklin.de
Publicité
