Publicité
• Acceleration and braking delay can be set separately
from each other. Any function button desired can be as-
signed using the function mapping.
• Typical sound backdrops for diesel and electric locomo-
tives are included.
• Variable motor feedback control is available in digital as
well as in analog operation.
• 6090, 60901, DC, and can motors with bell-shaped arma-
tures are supported.
• Function mapping included. See Help in the Central Sta-
tion 60213/60214/60215/60216/60226 or a detailed table to
function mapping can be found on the Internet at:
www.maerklin.de/de/produkte/tools_downloads/tech-
nische_informationen.html
• This unit can be updated with the 60213/60214/60215 CS2
(software version 4.0 or higher), the 60216/60226 CS3, or
with the 60971 Programmer.
• Programming on the Main (PoM) this type of program-
ming must be supported by the controller. Please note the
instructions for your controller when doing this.
• Switching range can be set.
• Braking / signal stopping block recognition is available in
digital operation.
• Automatic calibration of a locomotive with CV 7 (mfx, DCC,
MM).
Decoder Installation
The locomotive must be checked before installing the de-
coder to make sure that it (locomotive) is in good mechanical
and electrical condition. There are situations when the loco-
motive will have to be repaired before installing the decoder.
Remove the body, unplug the ribbon cable for the lighting
from the socket, or unsolder the orange, yellow, and gray
wires from the
lighting..
Loosen the four screws for the
circuit board.
Example: It's possible that there may be differences from
model to model.
29
Publicité
