USER MANUAL LABELS
Five adhesive labels are supplied with your Fieldmeter. They are simplified reminders about
how to use your instrument. This information is available in five languages. Choose your label
and carefully stick it to the back of your instrument. Now you will always have the information
necessary to use your Fieldmeter.
Your Fieldmeter consists of a case and a probe. To connect it, simply position it in the axis
of the case, turn the probe and push it in. Lock in position by pulling the black ring on the probe
towards the case (multi-contact push-pull socket).
Never try to turn the probe when it is fitted to the case, you may cause damage
to the sensor and its connections.
To switch On the instrument, position the rotary switch to one of the On positions corres-
ponding to the type of measurement to make. The display makes a general self-test, then
shows (top right) the remaining service life as a % (150% maximum for a new battery), finally,
the result of the measurement is displayed with the appropriate symbol (measurement unit,
function...). Choose a special function if necessary by pressing the corresponding button
when switching On (See SPECIAL FUNCTIONS).
The measurement of the field is done by moving the aerial in the environment to be measured.
You obtain a direct wide band measurement of the field that the measurement sensor is
subjected to. To find the value of the field emitted by a source of interference, simply point the
aerial towards it and get as close as possible (the value of the field is inversely proportional
to the distance of the sensor/emission source).
To switch Off the instrument, set the switch to Off (the display goes blank). Auto Off may be
triggered if you have not turned the switch or pressed the buttons during 10 minutes of
operation. In this case, if you want to wake up your Fieldmeter, simply press any button or turn
the switch (except to the OFF position). The display comes On again and the instrument starts
taking measurements again without taking into account the button pressed to wake it up.
After your measurements, position the switch to OFF and preferably put your Fieldmeter away
in its case. To do this, remove the probe by undoing the locking ring (in the axis, push the ring
of the case towards the probe) then carefully separate the two parts and put them away.
USE
51