Scan; Writing A Number - Chauvin Arnoux C.A 43 FILEDMETER Mode D'emploi

In program mode (PRGM displayed), five values can be set by pressing different buttons :
Low alarm
High alarm
Memorisation session
Current time
Print rate
(*) The digital value which is displayed corresponds to the contents of the program memory for the chosen
function. If no value had been programmed before, three hyphens appear.
Note :
Before entering the values, check the position of the rotary switch and the type of probe used.
The choice of unit depends on this position (A/m, V/m, µW/cm²). Manipulation of the switch,
or changing the probe, exits the Fieldmeter from the program mode.

WRITING A NUMBER

After having chosen the function to program, the former value (a number or three hyphens)
is displayed. If three hyphens are displayed, simply press
display the minimum value (0 for the alarms, 1mm for the clock, Dt and SCAN).
Automatically, the digit on the right flashes: this is the active digit.
To increase the value of the active digit, keep
the value, keep
or downwards (...3, 2, 1, 0, 9, 8, 7 ...) automatically increases or decreases the figure(s) to
the left of this. Release the button when the required digit is shown.
If during the operation increasing or decreasing the digit, the maximum or minimum capacity
of the display is exceeded, three hyphens again appear.
The and
want to program respectively to the left, or to the right.
Press button
1st press
2nd press
1st press
2nd press
1st press
pressed in. Changing the active digit upwards (...7, 8, 9, 0, 1, 2 ...)
buttons allow you to move the active digit (flashing) that you
*
ALARM
ALARM
¿
¿

SCAN

pressed in. Likewise, to reduce
67
Symbol on screen
LO
AL
HI
AL
Dt
¿
SCAN
or to