Manual Correction - Chauvin Arnoux C 320 Notice De Fonctionnement

4.2.2

MANUAL CORRECTION

This function can be used only if the temperature probe is not connected.
For the adjustment, the temperature of the product to be measured must be
displayed.
The factory setting of this parameter is MAN 25.0.
Example: solution or standard at 20.0°C:
Press the:
The instrument switches to manual
temperature adjustment
The numerical display then indicates the manually set temperature.
Press the:
To set to the desired value
Then on the:
The instrument then returns to the
conductivity measurement mode.
Note: adjustment from: 00.0 to 200°C
Conductimeter C 320
10.00 MICRO/CM
MAN 25.0
key
25.00 REG MAN
or
20.00 REG MAN
key to validate.
10.00 MICRO/CM
MAN 20.0
English
key
35