Publicité
Insert the puller (I) into the carrier plate as
shown and turn counterclockwise to the
stop.
Support the machine with one hand.
Remove the carrier plate (1) by pulling on
the puller (I).
166
Installing the carrier plate:
Thoroughly clean the blade shaft (1) and
the mounting on the carrier plate (2). Push
the carrier plate as far as possible onto the
blade shaft.
● Install the mowing blade. (
16.7 Finding a wire break
In the event of a wire break, the red
LED on the docking station flashes
rapidly. (
13.1) A corresponding
message appears on the display of
the robotic mower.
If a wire break cannot be found as
described, contact your specialist
dealer.
The wire break search can be performed
either with the control panel removed or
inserted. The control panel should be
inserted for the fine search.
● Before finding the wire break, the button
on the docking station must be pressed
once (LED continues to flash rapidly).
● Remove the docking station cover and
open the panel. (
9.2)
1 Fold open the left clamping lever (1).
2 Remove the wire end (2) from the
terminal block and then close clamping
lever again.
● Open the panel and fit the docking
station cover. (
16.4)
The following instructions describe how to
search for a wire break in a clockwise
direction, i.e. the perimeter wire is followed
in a clockwise direction starting at the
docking station. If necessary, the search
can also be carried out counterclockwise,
but in this case the right wire end must be
removed from the terminal block.
● Remove the control panel if necessary.
(
15.2)
● In the "More - Service" menu, select the
"Find wire break" entry and confirm with
OK. (
11.16)
9.2)
0478 131 9954 C - EN
Publicité
