Publicité
As the robotic mower follows the edge,
walk behind it and ensure
– that the robotic mower follows the edge
of the mowing area as planned,
– that the clearances to obstacles and the
borders of the mowing area are correct,
– that docking in and out takes place
correctly.
The distance covered is shown on the
display – this metric specification is
required for setting starting points at the
edge of the mowing area. (
● Read off the displayed value at the
required location and write it down.
Manually set starting points after initial
installation.
The following of edges is automatically
interrupted by obstacles, during operation
on excessively steep slopes or by pressing
the STOP button.
● If edge following has been interrupted
automatically, correct the position of the
perimeter wire and remove any
obstacles.
134
● Check the position of the robotic mower
before continuing edge following. The
machine must either be located on the
perimeter wire or within the mowing
area with the front facing the perimeter
wire.
Continuation following interruption:
After an interruption, continue edge
following with Yes.
No ends following of the perimeter wire
and the next step of the installation
assistant is called up.
11.14)
Recommendation:
Do not cancel edge following.
Possible problems when following
the edge of the mowing area or
when docking may not be
recognised.
Edge following can be repeated
following initial installation if
necessary. (
The robotic mower docks after one
complete circuit around the mowing area.
Then a second edge-following run is
started in the opposite direction.
Automatic completion of edge
following:
The next step of the installation assistant is
called up when the robotic mower docks
following the second complete circuit.
9.13 Programming the robotic mower
Enter the size of the lawn and
confirm with OK.
11.13)
A new mowing plan is calculated.
The procedure can be aborted using the
red STOP button on the top of the
machine.
Installed no-go areas and
secondary areas must not be
included when calculating the size
of the mowing area.
0478 131 9954 C - EN
Publicité
