Publicité
Check the breast pump kit parts for wear or damage before use and replace
them if necessary.
Note: Correct placement of the cushion and the silicone diaphragm is
essential for the breast pump to form a proper vacuum.
Note: The figure numbers mentioned below refer to the numbers of the
figures on the back foldout page of this user manual.
1 Insert the white valve into the pump body from underneath. Push the
valve in as far as possible (Fig. 2).
2 Screw the pump body clockwise onto the bottle (Fig. 3) or storage cup
(Fig. 4) until it is securely fixed.
Note: If you use a storage cup, you have to screw the adapter for cup
onto the storage cup first (Fig. 4).
3 Push the stem into the silicone diaphragm fully to the end (Fig. 5).
4 Insert the silicone diaphragm into the pump body from above. Make sure
it fits securely around the rim by pressing down with your fingers to ensure
a perfect seal (Fig. 6).
5 Attach the handle onto the diaphragm with stem by hooking the hole
in the handle over the end of the stem. Push down the handle onto the
pump body until it clicks into place (Fig. 7).
Place the cushion into the pump body (Fig. 8) and make sure that the rim
6
covers the pump body. Push the inner part of the cushion into the funnel.
Make sure that you push the cushion inwards completely, up to the line
indicated with an arrow on the pump body (Fig. 9).
Note: Place the cushion cover over the cushion to keep the breast pump
clean while you prepare for expressing.
Using the breast pump
Warning: Always use the breast pump with the cushion.
Note: Contact your healthcare professional in case of questions or if you
experience side effects.
Operating the breast pump
1 Wash your hands thoroughly with soap and water and make sure that
your breast is clean.
2 Press the assembled pump body against your breast. Make sure that your
nipple is centered, so that the cushion creates an airtight seal.
9
English
Publicité
