Publicité
en-us Prepare installation space
¡ Solid surface countertops often require special
installations. For example, heat-reflective tape and
rounded corners may be necessary.
¡ Contact the countertop manufacturer for instructions
specific to your countertop.
Prepare installation space
3 Prepare installation space
Create the cutout in the countertop according to the
Prepare installation space
instructions.
General countertop requirements:
¡ The angle of the cut surface to the countertop surface
must be 90°.
¡ With multi-layered countertops, secure strips laterally in
the cutout if necessary.
¡ After creating the cutout, remove all debris.
¡ Seal the cut surfaces in a heat- and water-resistant
manner.
¡ Observe the minimum distance between device
underside and cabinet surfaces of ⅜" (10 mm).
¡ The countertop into which the cooktop is installed must
be heat-resistant up to 140° F (90 °C).
¡ The countertop into which the cooktop is installed must
be at least ¹³/₁₆" (20 mm) thick.
¡ If the thickness of the countertop into which the cooktop
is installed does not comply with the specifications,
reinforce the worktop using a fire- and water-resistant
material until it reaches the minimum thickness.
Otherwise, sufficient stability cannot be assured.
¡ The countertop into which the cooktop is installed
should withstand loads of approx. 133 lbs (60 kg).
¡ Confirm the cooktop is level only after it has been
installed.
3.1 Cutout dimensions for 24" cooktops
Refer to these measurements for the models stated here.
¡ NIT5460UC
¡ NIT8461UC
6
3.2 Cutout dimensions for 30" cooktops
Refer to these measurements for the models stated here.
¡ NIT5060UC
¡ NIT8061UC
¡ NIT8060SUC
¡ NIT8060UC
¡ NITP060SUC
¡ NITP060UC
Publicité
