Publicité
2 Before you begin
Before you begin
Read these instructions before you begin to install your
Before you begin
appliance.
This Installation Instructions covers several models. All
graphics are representative. Your appliance may vary in
appearance and features.
2.1 Parts included
After unpacking all the parts, check for any damage in
transit and for completeness of delivery.
2.2 Tools and parts needed
Prepare these tools and accessories before you start to
install your appliance.
¡ Pencil
¡ Measuring tape
¡ Cross head screwdriver
¡ Drill with bit 1/4" (6 mm)
¡ Jigsaw
Note: Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.
2.3 Cabinet requirements
Ensure that the cabinetry at the installation location meets
the requirements for a safe installation.
¡ The distance from the top of the cooktop to the bottom
of cabinets above must be a minimum of A=30"
(762 mm).
¡ This distance can be reduced to A=24" (610 mm) when
the bottom of the wood or metal cabinet is protected by
not less than ¼" (6.35 mm) flame-retardant millboard
covered with not less than no. 28 gauge sheet metal,
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm)
aluminum or 0.020" (0.5 mm) copper.
¡ Verify that unprotected cabinets above the cooktop are
a maximum of B=13" (330 mm) deep.
Installation of a cooktop over ovens and
microwaves
Only certain models may be installed over an oven or a
microwave. Verify the Approved Combination Guide
supplied with these instructions for approved installation
combinations. Both products will have a label stating
Approved Combination Guide.
Installation of a range hood or a microwave hood
above the cooktop
Follow the range hood or microwave hood installation
instructions for dimensional clearance above the cooktop
surface.
2.4 Countertop requirements
Ensure that the countertop into which the cooktop is to be
installed meets these requirements for a safe installation.
WARNING
To reduce the risk of ignition of surrounding combustible
materials, install at least 2" (51 mm) from both sidewalls
and the rear wall.
¡ The countertop must be level and horizontal.
¡ The stability of the countertop must be maintained after
the cut-out has been made.
Before you begin en-us
5
Publicité
