SilverCrest SDM 1500 D3 Instructions De Montage, D'utilisation Et Consignes De Sécurité page 13

Power knob
Turn in clockwise direction Turn the product on .
Turn in counter-clockwise
direction to "0" position .
NOTES:
The product needs around 30 seconds to
preheat . After preheating, the pump starts
operating . The steam runs continuously until the
water tank 18 is empty .
When the product is powered on, it should not be
pointed towards equipments containing electrical
components (such as the interior of ovens) .
The product has to be unplugged
– after use,
– before cleaning, and
– before maintaining
the product .
˜ Adjusting the steam power
Power knob
Turn in clockwise direction Increase steam power
Turn in counter-clockwise
direction
˜ Pump safety shutdown
When the water tank 18 is empty, the pump
keeps operating for about 1 minute . Then, it shuts
down .
The light indicator 19 changes from continuous
green to flashing red colour .
Turn off the product . Refill the water tank 18 to
proceed with the operation .
21 On/off
The light indicator 19
turns green .
Turn the product off .
The light indicator 19
goes off .
21 Steam power
Decrease steam power
˜ Cleaning and care
Cleaning the main unit
m
DANGER! Risk of electric shock!
Disconnect the power plug 23 from the wall
socket before cleaning the product .
m
WARNING! Do not immerse the product's
electrical components in water or other liquids .
Never hold the product under running water .
Wipe down the product with a slightly damp
cloth .
Do not let any water or other liquids enter the
product interior .
Do not use any abrasive, aggressive cleaners or
hard brushes to clean the product .
After cleaning: Let all parts dry completely .
Cleaning the accessories
Clean the accessories in warm, soapy water .
After cleaning: Let all accessories dry completely .
Cleaning the microfiber cloths and
microfiber cover
The microfiber cloths 14 and the microfiber
cover 8 can be cleaned in a washing machine and
in a dry cleaner .
Clean the microfiber cloths 14 and the microfiber
cover 8 with a mild setting, up to 60 °C .
After cleaning: Let all parts dry completely .
GB/IE/NI 13