Publicité
ENGLISH
To disable a function (fig. 28):
1) press the FUNCTION button for more than 2 seconds.
2) press the SPEED button to select one of the three LEDs
(LED 1, LED 2, LED 3) corresponding to the
AUTONIGHT / AUTO HR% / AUTO COMFORT function
to be disabled.
3) press the MODE button to disable the function.
4) to SAVE the settings, press the FUNCTION button for
more than 2 seconds. All SPEED LEDs blink 4 TIMES
to indicate correct storage.
5) to CANCEL and exit the setting procedure, press the
FUNCTION key once. All SPEED LEDs blink ONLY
ONCE WITHOUT SAVING any changes made.
6) to CHECK which function is assigned to the appliance,
press the FUNCTION button for more than 2 seconds: :
the LED corresponding to the set function blinks for
about 20 seconds, then all the speed LEDs flash and
the device returns to standard display.
D: FILTER LED
One led (D - fig. 26B) shows the status of the filters:
• LED OFF: filters are clean
• LED ON: filters to be cleaned or replaced (for each day of operation, a counter in the memory is increased
and when the maximum preset time is reached (90/180/365 days), the signalling LED lights up).
Refer to section "maintenance and cleaning".
CLOSING OF THE DEVICE
To avoid air to come inside the room, set the device in stand-by mode by pressing the FUNCTION key (LEDs in
the SPEED column switch off) and turn the lever to close position (fig. 29).
29
29
1
2
28
28
LED
EXTRACTION /AUTO COMFORT
LED
INTAKE /AUTO HR%
LED
RECOVERY/AUTO NIGHT
FUNCTION
BUTTON
1
LED 5
LED 4
LED 3
LED 2
LED 1
MODE
SPEED
BUTTON
BUTTON
3
2
Publicité
