Start-Up; General Information; Wireless Outdoor Sensor; Base Station - ADE WS 2132 Mode D'emploi

Start-up

General Information

‚ Proceed according to the order listed below and
first insert the batteries into the wireless outdoor
sensor. Only then can the weather station function
without flaws.
‚ Do not use rechargeable batteries, since their
voltage is too low (only 1.2 V instead of 1.5 V). This
affects, among other things, the precision of the
measurements.
‚ Where possible, use alkaline rather than zinc-
carbon batteries. Alkaline batteries last longer,
especially at low outdoor temperatures.

Wireless outdoor sensor

1. Push the battery compartment cover on the back
of the outdoor sensor open using a little force.
2. Insert two LR03/R3 (AAA) batteries as shown on
the bottom of the battery compartment. Observe
the correct polarity (+/-).
3. Slide the battery compartment cover back on.

Base station

1. Press down the locking tab of the battery
compartment cover and fold down the
compartment cover.
2. Insert two LR06/R6 (AA) batteries as shown on the
bottom of the battery compartment. Observe the
correct polarity (+/-).
Weather station with ventilation recommendation WS 2132 51