Setting Up The Base Station; Setting Up The Outdoor Sensor - ADE WS 2132 Mode D'emploi

‚ Depending on your location, it can infrequently
happen that the base station receives signals from
another time signal transmitter or even alternately
from two time signal transmitters. This is not a
fault in the device. In this case, change the location
of the base station.
‚ The weather, e.g. a heavy storm, can cause
interference with the reception.
‚ Temporary shutoffs of the transmitter can
sometimes happen, e.g. because of maintenance
work.

Setting up the base station

− Set up the base station as close to a window as
possible. Here, the reception will generally be best.

Setting up the outdoor sensor

DANGER of severe injuries
− During wall installation, there must be
The wireless outdoor sensor is equipped with a
hanging eyelet on the rear side.
− Place or hang the outdoor sensor at a position
where it is protected from the direct influence of
the weather (rain, sun, wind, etc.).
Weather station with ventilation recommendation WS 2132
58
no electrical cables, gas or water pipes
installed in the walls at the mounting
site. Otherwise, when drilling holes,
there is a risk of electric shock!