Start-Up; Wireless Outdoor Sensor; Base Station With Radio - ADE WS 1604 Mode D'emploi

Start-up

Start-up
‚ Proceed according to the order listed below and first insert the batteries
into the wireless outdoor sensor. Only then can the weather station
function without flaws.
‚ Do not use rechargeable batteries, since their voltage is too low (only
1.2 V instead of 1.5 V). This affects, among other things, the precision of
the measurements.
‚ Where possible, use alkaline rather than zinc-carbon batteries. Alkaline
batteries last longer, especially at low outdoor temperatures.

Wireless outdoor sensor

1. Remove the battery compartment cover on the rear side of the outdoor sensor by
pressing with a little force on the imprinted arrow. Slide the battery compartment
cover in the direction of the arrow, away from the outdoor sensor.
2. Insert 2 batteries of type LR03 (AAA)/1.5 V as depicted on the bottom of the battery
compartment. Pay attention to the correct polarity of the batteries (+/-).
3. Slide the battery compartment cover back into place on the outdoor sensor.

Base station with radio

NOTE on material damage
− Use only the supplied mains adapter.
You can also operate the base station without a backup battery. Operation
with only the battery - without connecting to the mains - is not possible.
In the event of a power outage, a 3 V CR2032 battery ensures that settings made
(e.g. alarm times) remain stored for several hours. Upon delivery, the backup battery
is already inserted and is provided with an iso strip to protect against premature
discharge.
1. Loosen the screw on the battery compartment cover on the underside using a fine
Phillips screwdriver.
2. Remove the battery compartment cover.
3. Pull out the iso-strips.
4. Replace the battery compartment cover and secure it in place using the fastening
screw.
5. Unwind the FM wire antenna and attach the end as high as possible to a wall or a
shelf, e.g. with adhesive tape.
38
Weather station with radio alarm clock WS 1604