Seca 284 Mode D'emploi Et Garantie page 98

Activate acoustic
signals (bEEP)
Select attenuation (Fil)
98 •
You can set whether an acoustic signal is to be emitted
whenever a key is pressed or a stable weight value has
been attained. The latter is relevant for the Hold/
Autohold function.
1. Select the item "bEEP" from the menu.
2. Confirm the selection.
3. Select a menu item
– Press: acoustic signal whenever a key is
pressed
– Hold: acoustic signal with a stable weight
value.
4. Confirm the selection.
The current setting is displayed.
5. Select the setting you require:
– On
– Off
6. Confirm the selection.
You will leave the menu automatically.
7. If you also wish to activate the acoustic signals for
the second function, repeat this process.
You can use attenuation (Fil = filter) to reduce any
interference during weighing. The selected setting
affects the sensitivity with which the weight display
responds to patient movements and the time until the
"Hold" function continuously displays a weight value.
1. Select the item "Fil" from the menu.
2. Confirm the selection.
The current setting is displayed.
3. Select an attenuation level.
Fil Weight display
0 Sensitive
1 Average
2 Sluggish
NOTE
• With the setting "0", it is possible that despite
the "Hold" function being activated, a
continuous weight value is not displayed for
patients who are not so steady.
Hold
Slow
Average
Fast