Publicité
Les langues disponibles
Les langues disponibles
Replacing the disk brushes
Lift the cleaning head.
Press the pedal for changing the
brushes downward beyond its re-
sistance.
Pull the disc brush out of the side
below the cleaning head.
DANGER
Risk of injury! Before carrying out any
tasks on the machine, set the main key
to "0" and remove it. Pull the battery
plug.
Drain and dispose of the dirt water
and the residual fresh water.
Fault
Appliance cannot be started Seat switch not operated, sit down on the seat.
Machine does not move
Insufficient water quantity
Insufficient vacuum perfor-
mance
Insufficient cleaning result
Speed of suction turbine has
increased
Brush does not turn
In case of faults that cannot be remedied using the table below please contact the customer service.
Hold the new disc brush under the
cleaning head, push upward and
lock.
Troubleshooting
CAUTION
Risk of injury due to overrun of the suc-
tion turbine.
Suction turbine will continue to run for
a while after switch-off. Carry out main-
tenance tasks only after the suction
turbine has come to a halt.
Remedy
The machine operates only if the operator is seated on the seat.
Insert battery plug.
Set the key switch to "1".
Take your foot off the accelerator before switching on the key switch. If the fault recurs, call
aftersales service.
Check battery; charge it, if needed
Press the unlocking lever downwards (see "Transport/Pushing the appliance").
Increase the water volume on the regulating knob for water volume.
Check fresh water level, refill tank if necessary.
Clean the fresh water filter.
Check hoses for blockages; clean if required.
Wastewater reservoir is full; shut off the appliance and empty the wastewater reservoir
Clean the seals between waste water tank and cover and check for tightness, replace if re-
quired.
Check the fluff filter for soiling, clean if necessary.
Clean the vacuum lips on the vacuum bar, turn or replace if required
Check if the vacuum bar is plugged, remove plug if required
Check if the cover on the dirt water discharge hose is closed
Check suction hose for blockages; clean if required.
Check the suction hose for tightness; replace if required.
Check dirt water drain hose to see it is leak-proof.
Check the setting of the vacuum bar.
Attach additional weight (accessory) to the vacuum bar.
Check the brushes for wear, replace if required.
Check the brush type and the detergent for their suitability.
Empty the waste water tank.
Clean the swimmer.
Check / clean the lint trap.
Check suction hose for blockages; clean if required.
Check if the vacuum bar is plugged, remove plug if required
Check if foreign matters block the brushes; remove foreign matter if required.
11
-
EN
Frost protection
In case of danger of frost:
Empty the fresh and dirt water res-
ervoirs.
Store the appliance in a frost-pro-
tected room.
In case of faults that cannot be reme-
died using the table below please con-
tact the customer service.
13
Publicité
