Connection Example; Connecting 15K Rgb/Component Equipment - Sony VPL-W400Q Mode D'emploi

Connection Example

For details on how to conncet a VCR or external active
speakers, see page 14. Also refer to the instruction
manual of the equipment to be connected.
When making connections, be sure to:
• Before connecting any cables, make sure that each
piece of equipment to be connected is turned off.
• Use cables appropriate for the equipment to be
connected.
• A loose connection may cause hum or noise.
• When disconnecting a cable, pull it out from the plug;
not the cable itself.

Connecting 15k RGB/Component Equipment

15k RGB/component equipment
to a wall outlet to AC IN
AC power cord
(supplied)
Notes
• This unit cannot accept separate sync signal with 15k
RGB/component input signal. Use composite sync
(negative) or Sync on Green.
..........................................................................................................................................................................................................
1) The picture may not be correctly displayed when an HDTV signal with external sync signal is input. To view the
HDTV signal, input the G signal with the sync signal or Y signal with the sycn signal, to the INPUT-A G/Y connector.
Do not connect the external sync signal to the INPUT-A C. SYNC connector.
Front
VIDEO IN VIDEO IN AUDIO IN
L (MONO)
S VIDEO VIDEO
Connecting a BNC connector:
2 Twist to the right.
1 Align the pins with the pin holes and
to RGB/component output
Connecting cable (not supplied)
INPUT-A
R R/R-Y/P G/Y B/B-Y/P C.SYNC
R B
• Select the RGB, COMPONENT, HDTV signal
the INPUT-A item on the SET SETTING menu.
push in the plug into the socket.
HDVS
AUDIO IN
L R
1)
32
with
(EN)