Connection Examples; Connecting Directly To The Projector - Sony VPH-D50Q Mode D'emploi

Connection Examples

When making connections:
• Before connecting any cables, make sure that each
piece of equipment to be connected is turned off.
• Use cables appropriate for the equipment to be
connected.
• A loose connection may cause hum or noise.
• When disconnecting a cable, pull it out by the plug;
not the cable itself.
• Also refer to the instruction manual of the equipment
to be connected.

Connecting Directly to the Projector

TRIGGER
IN OUT
RS-422A
PLUG IN POWER
CONTROL S REMOTE
Color monitor
Video equipment
38
(EN)
Use the IFU-1271/1271M Signal Interface Unit.
Rear
IN OUT
ABL LINK Y IN
IN OUT IN
INDEX VIDEO S VIDEO
to video input
to video output
to S Video output
Setting up
• Set INPUT-A in the SET SETTING menu to RGB.
For details, see "The SET SETTING Menu" on page 31 (EN).
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote control or by setting VIDEO in the INPUT SELECT menu.
For details, see "The INPUT SELECT Menu" on page 25 (EN).
Connecting a BNC connector:
2 Twist to the right.
1 Align the pins with the pin holes and
push the plug into the socket.
C IN
R G B SYNC/HD VD
REMOTE1
OUT R-Y/P Y B-Y/P
R B
INPUT A IN
to RGB output
IFU-1271/1271M
to RGB
input
IFB-12
to RGB output
to RGB Input
MODE
OUT
Color monitor
Computer