LIVARNO LUX HG06659B Instructions De Montage, D'utilisation Et Consignes De Sécurité page 23

Connect the lead of the cable with the terminal block
nection box
(L for live, N for neutral and
13
Close the connection box
Align the spotlight
need to slacken the fastening screws
tighten the fastening screws
Reinsert the fuse or switch the circuit breaker back on. Your product is now
ready to use.
Start-up
Adjusting the motion detector
Depending on the pre-adjustments of the motion detector
will switch itself on for a certain period of time as soon as the motion
1
detector detects movement. These pre-adjustments are made using the
9
three controllers on the underside of the motion detector
Setting the lighting duration
Turn the rotary control TIME
the illumination. The lighting duration can be adjusted within a time win-
dow of approx. 10 seconds to 4 minutes.
Adjusting the sensitivity of the sensor
Turn the rotary control SENS
the sensor.
Note: The motion detector
door temperatures are low, it is more sensitive to body heat than
. Pay attention to the markings on the terminal block
6
.
6
into the desired direction. For this, you may
1
8
11
10
9
for the earth wire) (Fig. C).
. After finish the alignment,
8
again, to ensure a secure hold.
clockwise to increase the duration of
clockwise to increase the sensitivity of
responds to heat radiation. When out-
in the con-
13
, the spotlight
9
(Fig. B).
9
GB/IE 23