Publicité
Les langues disponibles
Les langues disponibles
Installation
Make sure you will not be drilling into electrical, gas or water lines inside
the wall. Use a power drill to drill the holes into the brick wall. Always ob-
serve all safety instructions for the power drill in the manual for the power
drill. Death or injury due to electric shock may otherwise result.
When selecting the mounting location, pay attention to the following:
Make sure that the spotlight
move the spotlight
Make sure the motion detector
detector
9
age angle of about 180° (depending on the mounting height – a
height of 2.50 m is ideal) (Fig. D).
Make sure the motion detector
lighting. This can influence its functioning.
During mounting, proceed as described below:
Unscrew locking screw
detach the mounting stirrup
Hold the mounting stirrup
spirit level) against the wall and mark the fastening holes.
Now drill the fastening holes (Ø 6 mm) and push the wall plugs into
the drill holes (Fig. A).
Secure the mounting stirrup
N ow use the screw driver (cross type) to attach the spotlight
mounting stirrup
spring washer
Open the connection box
connection box
Insert the connection cable (not include in the product), type H05RN-F
3G 1.0 mm
, through the cable gland
2
. The length for the connection cable line should not exceed 2.5 m.
6
Fix the connection cable with the cable clamp
turning the nut of the cable gland
22 GB/IE
1
vertically.
1
has a maximum coverage range of 12 m, with a cover-
by using a screw driver (cross type) to
5
4
4
4
by using the previously removed locking screw
4
, and metal nut
2
6
with a cross type screwdriver.
6
illuminates the desired area. You can
covers the desired area. The motion
9
is not illuminated at night by street
9
from the spotlight
so that it is horizontal (possibly with a
onto the wall using the screws provided.
(Fig A).
3
after you have released the lid of the
and into the connection box
7
.
7
.
1
to the
1
first and then by
14
,
5
Publicité
