Publicité
Les langues disponibles
Les langues disponibles
♦
Manually add 3–5 drops of pneumatic oil from
the supplied oil container
nipple
after every 15 minutes of operation .
♦
When opening the oil container
time, remove the cap nut from the container .
Use a pair of long-nosed pliers or a similar
implement to remove the internal pipette .
♦
Turn it 180°, replace it and screw it back in
place with the cap nut .
♦
Use a needle or similar tool to poke a small
hole into the tip of the pipette to release oil .
Connecting to a compressed air
source
NOTE
►
Before connecting the compressed air source,
–
the correct working pressure (3–6 bar)
must be fully reached
–
ensure that the trigger
♦
Pull the supply hose connector over the quick-re-
lease fastener on the connecting nipple
it clicks into place .
NOTE
The compressed air source must be equipped with
a pressure reducer to ensure that you can regulate
the air pressure .
Use
♦
The appliance is ready for use as soon as the
pneumatic air flow has been established .
♦
Screw the pin collector
the pin collector
♦
Determine the suitable rivet size on the basis of
the workpieces used .
♦
Use a suitable tool to drill a hole into the work-
pieces in the spot where the rivet
located . Make sure the diameter of the hole
corresponds to the determined rivet size .
■
6
│
GB │ IE │ NI
into the connecting
for the first
is not pulled
onto the thread for
at the back of the machine .
will be
CAUTION!
►
Suitable safety precautions must be taken
depending on the size and nature of the
workpieces . Use suitable clamping devices to
prevent the workpieces from slipping .
►
In the event of an interruption to the air sup-
ply, release the trigger
►
Before switching on the machine, make sure
the machine tool is firmly placed on the
surface to be processed .
♦
Check if the diameter of the attached mouth-
piece
matches the mandrel diameter of the
determined rivet size .
♦
If it does not, unscrew the front connector
using the assembly spanner
CAUTION!
►
Ensure that the appliance is disconnected
from the compressed air source before you fit
or remove the front connector
♦
If necessary, unscrew the mouthpiece
until
the front connector
ner
. Afterwards, screw the correct spare
mouthpiece
tighten it .
♦
To attach the front connector
the thread (you will feel minor resistance) and
tighten it by hand .
♦
Tighten the front connector
bly spanner
♦
Reconnect the appliance to the compressed air
supply .
♦
Place the rivet body in the drill hole .
♦
Slide the appliance over the rivet
mandrel is fully inserted into the mouthpiece
♦
Pull the trigger
the device, detached from the rivet body and
the rivet joint is established permanently .
If necessary, repeat the process until the man-
drel has been fully separated from the rivet
body .
NOTE
You will need to tip the appliance to the rear to
get the mandrel into the waste collector
immediately .
, if necessary .
.
using the assembly span-
into the front connector
, press it onto
using the assem-
.
until the
. The mandrel is pulled into
PDBNP 14 B1
from
and
.
.
Publicité
