Publicité
Les langues disponibles
Les langues disponibles
Hazards during operation
■
When using the machine, the operator's hands
may be exposed to hazards such as crushing,
impact, cuts, abrasions and heat . Wear suitable
gloves to protect your hands .
■
The operator and maintenance personnel must
be physically capable of handling the size,
mass and power of the machine .
■
Hold the machine correctly: Be ready to coun-
teract any normal or sudden movements – keep
both hands ready .
■
Ensure that your body is balanced and that you
have a secure standing position .
■
Release the start/stop control in case of a
disruption to the electricity supply .
■
Use only the lubricants recommended by the
manufacturer .
■
Avoid inappropriate postures as these postures
are likely to make it impossible to respond to
normal or unexpected movements of the ma-
chine .
■
If the machine for threadless fasteners is at-
tached to a suspension device, the attachment
must be secured,
■
There is a risk of crushing if the equipment is not
attached to the machine head .
Hazards caused by repetitive
movements
■
When using a machine for threadless fasteners,
operators may experience uncomfortable sensa-
tions in their hands and arms, as well as in the
neck and shoulders or other parts of the body .
■
When using a machine for threadless fasten-
ers, the operator should adopt a comfortable
posture . Ensure that you have a secure foothold
and avoid unfavourable postures or postures
in which it is difficult to maintain balance . The
operator should change positions during the
course of long-lasting tasks . This can be helpful
for the prevention of discomfort and fatigue .
■
If the operator notices symptoms such as
persistent or recurring illness, discomfort, throb-
bing, pain, tingling, burning or stiffness, these
indications should not be ignored . The operator
should consult a suitably qualified physician .
■
4
│
GB │ IE │ NI
Hazards caused by accessories
■
Disconnect the machine for threadless fasteners
from the power supply before replacing the
machine tool or accessories .
■
Use only accessories and consumables of the
sizes and types recommended by the manufac-
turer of the machine for threadless fasteners; do
not use any other types or sizes of accessories
or consumables .
Hazards in the workplace
■
Slipping, tripping and falling are the main
causes of injuries in the workplace . Look out
for surfaces which could have become slippery
through use of the machine, and also any trip-
ping hazards caused by air or hydraulic hoses .
■
Proceed with caution in unknown surroundings .
Hidden hazards caused by power or other
supply lines may be present .
■
This machine for threadless fasteners is not
suitable for use in explosive environments and
is not insulated against contact with power
sources .
■
Do not operate the appliance in the vicinity of
electric mains, gas pipelines, etc . which could
pose a hazard if damaged by the machine .
Risks due to noise
■
Excessive noise levels in conjunction with insuffi-
cient hearing protection may lead to permanent
hearing damage, hearing loss and other prob-
lems, such as tinnitus (ringing, buzzing, whistling
or humming in your ears) .
■
It is essential that a risk assessment is carried out
with respect to these risks and that appropriate
regulatory mechanisms are implemented .
■
Suitable regulatory mechanisms include mea-
sures such as the use of insulation materials
which avoid ringing noises occurring on the
workpieces .
■
Use ear protection equipment as per the instruc-
tions provided by your employer or as required
by health and safety regulations .
■
Consumables/machine tools should be selected,
maintained and replaced in accordance with
the recommendations in this guide in order to
avoid unnecessary increase of the noise levels .
PDBNP 14 B1
Publicité
