Publicité
Les langues disponibles
Les langues disponibles
Hoyer
®
Stature
*THESE CHECKS SHOULD INCLUDE:
= Recommended
ü
1. SPREADER BAR: Check the spreader bar for freedom of rotation and
swing. Check for wear on the central pivot. Check for firm attachment to the
boom.
2. BOOM: Check the attachment of the boom to the mast carriage. Make sure
there is only minimal movement.
3. MAST: Check it is firmly connected to the chassis.
4. MOTOR GEARBOX: This should require no maintenance other than
checking for correct operation and listening for unusual noise.
5. CONTROL BOX/SMART MONITOR: Check the function of the emergency
stop button. Inspect the hand control socket for correct fitting. Check
functioning of the hand control. Check the redundant controls and confirm they
operate as intended.
6. BATTERIES: The batteries are housed in the power pack and should not
require maintenance other than the regular charging as detailed in the
charging instructions. Check that the connections remain clean.
7. LEG ADJUSTMENT: Check the legs operate in both full extensions (in-
ward/outward).
8. CASTORS: Check all castors for firm attachment to the legs. Check for free
rotation of the castor and the wheels.
9. CLEANING: Clean with ordinary soap and water and/or any hard surface
disinfectant. Harsh chemical cleaners or abrasives should be avoided as
these may damage the surface finish of the lift. Avoid wetting any of the
electrical parts.
10. BASE AND WHEELS: Ensure base is even and level (all four wheels are
on the floor).
11. SLINGS: Check for wear and fraying.
12. LUBRICATION: Lubricate pivot joints with a silicone based oil, includ-
ing mast and boom connections, pedal assembly, spreader bar joint (only if
required),
13. HAND SET: Ensure plugged fully into controller.
14. QUICK RELEASE PIN: Ensure the pin is securely fitted before lifting.
15. HARDWARE: Check all nuts, bolts, screws and fasteners for excessive
wear and for tightness. Replace as required.
16. LIFTING STRAP: Your lift strap should be checked at service intervals
for any sign of wear (ideally every six months). In order to view the strap
it is recommended to remove the cap at the top of the mast, cycle the lift
in both directions whilst observing the condition of the strap. If you see
any wear (fraying, creasing or similar) it is recommended an authorised,
Joerns Healthcare Dealer or qualified, competent service engineer replaces
the strap IMMEDIATELY. For details regarding strap maintenance and
replacement please request our detailed service guide. (See below for details)
24
English
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
Publicité
