SilverCrest SMPSA 3.7 B1 Mode D'emploi page 19

Always start the treatment at the lowest setting and only increase it
o
when necessary .
1 . Before changing the attachment: Switch off the main unit each time .
2 . Pull the attachment, if any, out of the attachment fitting
3 . Insert the appropriate attachment (see "Attachments") for your purpose
in the attachment fitting
4 . Switch on the product: Press and hold
5 . Select the rotating direction: Press the rotating direction button
lower part of the indicator light
Lower part of the indicator light
Red
Green
6 . Increase the rotation speed: Press
7 . Decrease the rotation speed: Press
Indicator light
= on I = off
8 . Switch off the product: Press
INFO:
Set the speed to the lowest setting after you changed the rotating
direction or an attachment .
If you have treated hardened skin, apply a moisturising cream to the
treated areas after completing the procedure .
The attachments do not have as much effect on softened skin . Therefore,
do not carry out any pretreatment in a water bath before using the
product .
. The attachment must sit securely .
1 ] [
Speed level
5 ] [
Low
Medium
High
for 3 seconds . Release
[ 7 ]
shows the rotating direction:
[ 5 ]
Rotating direction
5 ] [
Counter-clockwise
Clockwise
.
[ 3 ]
.
[ 4 ]
.
[ 7 ]
.
1 ] [
.
. The
6 ] [
GB/IE/NI 19