SilverCrest SMPSA 3.7 B1 Mode D'emploi page 17

˜ First set-up of the product
˜ Unpacking the product
1 . Take the product out of the packaging and remove all packaging
materials and plastic wrappings .
2 . Check to make sure that all listed parts are included (see "Scope of
delivery") .
3 . Check whether the product and all parts are in good condition, if any
damage or defect is detected, do not use the product, but follow the
procedure described in chapter "Warranty" .
˜ Charging the product
m NOTICE! Risk of product damage!
To charge the rechargeable battery: Only use a class II supply unit (not
included in the scope of delivery) approved for use with household
appliances .
SELV output: DC 5 V, max . 1 A
Recommended: Model no . M26EU050100
Do not leave the product permanently connected to the USB cord
INFO:
Switch off the product before charging the battery .
o
When the battery level is low: The lowest part of the indicator light
o
flashes (red or green according to the rotating direction) . Charge the
product .
Once the product runs out of battery: The lowest part of the indicator
o
light flashes 3× red . The product switches off automatically . Charge
5 ] [
the product .
1 . Connect the USB cord
2 . Connect the USB type-A connector on the USB cord
power supply .
to the product .
8 ] [
.
8 ] [
5 ] [
to a suitable
8 ] [
GB/IE/NI 17