Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
..........................................................................................................................................................
STEP 1
Installing the Front & Rear Brace
REQUIRED
Side Rail Left / Right [2]
Front Brace [4]
Rear Brace [5]
4x M8x15mm Bolts [13]
6mm Allen Key [17]
NOTE
There is a pulley on the
Rear Brace[5]. Front
Brace[4] does not have a
pulley.
STEP 2
Tighten the Bolts at the Bottom of the Rails
REQUIRED
4xM5x15mm Bolts [12]
3mm Allen Key [16]
STEP 3
Mounting Rower Seat
REQUIRED
Left / Right Side Rail [2]
Rower Seat [3]
A) Connect the Rear Brace[5] to the rear of the Side Rail Left &
Right[2]. Make sure it is fully inserted. Insert the 4x M8x15
Bolts[13] into the holes from the inside of the Rails.
B) Connect the Front Brace[4] to the front of the Side Rails Left &
Right[2]. Make sure it is fully inserted. Assemble the 4x M8x15
Bolts[13] into the holes from the inside of the rails.
Flip the rail assembly over, insert the 4x M5x15 Bolts[12] into each
corner. Flip the rail assembly back to the correct assembly position.
Slightly push the Rails open and install the Seat into the Seat Runners.
The 4 guiding wheels at the bottom should be tucked under the baffle
of the Runner.
7
Publicité
