Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
..........................................................................................................................................................
STEP 7
Fixed the Bungee Cord and Completing the Rower Assembly
A) Remove the Inner Clip & Hook from the Bungee Cord.
B) Thread the Bungee through the 50mm Pulley as
shown in figure direction.
C) Reinstall the Inner Clip & Hook back to the Bungee
Cord. Reserve about 3cm length at the end of the
Bungee Cord.
D) Pull bungee cord and Hook Bungee end onto the
Bungee Hook mount as shown.
•
Lower the Rower back to the horizontal position and
test for proper bungee recoil.
•
Check seat rollers/runners for dirt or debris before
sitting on the Rower seat. Small objects captured
between the seat rollers and runners can damage the
wheels or running surface. Check runners for debris
prior to each use and clean regularly.
•
Note: The Rower frame bolts require periodic checking
for tightness. Do this at the end of the first month of
use and again after every 12 months.
•
Choose a suitable location when standing the product
for storage.
•
The Rower frame can be polished with any high grade
furniture polish to further highlight the rich luster of
the wood finish.
•
Install supplied 2x D Cell batteries and check monitor function. Details regarding can be found in
the monitor section of this manual.
•
Choose a flat, level surface on which to use your Rower, to avoid rocking and potential premature
wear.
•
Clean wheels and tracks weekly with a soft dry cloth in order to decrease the rate of wear on
both wheels and track.
STEP 8
Installing the Rail Support Plate
REQUIRED
2x M5x15 Bolts [12]
Rail Support Plate [19]
Use two M5x15 Bolts[12] to secure the Rail
Support Plate[19].
9
(A)
(B)
(C)
(D)
The Bungee Cord may
be separated from the
Pulley during installation
or transportation. After
installation, make sure the
Bungee Cord is correctly
installed on the pulley.
Publicité
