GE GFD48 Manuel D'utilisation Et Instructions D'installation page 8

Control settings.
4
5
6
7
My Cycle
Hold 3 Secs to Store Cycle
(Depending
on model)
8
Add Time
Press to add time to the Steam Dewrinkle,
Warm Up, Air Fluff or Time Dry cycles in 10
minute increments.
Temp
You can change the temperature of your dry
cycle.
High For regular to heavy cottons.
Medium For synthetics, blends and items labeled Permanent Press.
Low For delicates, synthetics and items labeled Tumble Dry Low.
Extra Low For lingerie and special-care fabrics.
No Heat This option may only be used with Air Fluff, in which items are tumbled without
heat.
Level
The sensor continuously monitors the amount of
moisture in the load. When the moisture in your
clothes reaches your selected dry level, the dryer
will stop.
Extra Dry Use for heavy-duty fabrics or items that should be very dry, such as towels.
(on some models)
More Dry Use for heavy or mixed type of fabrics.
Dry Use for normal dryness level suitable for most loads. This is the preferred cycle for energy
saving.
Less Dry Use for lighter fabric (ideal for ironing).
Damp For leaving items partially damp.
My Cycle
Set up your favorite combination of settings
and save them here for one touch recall. These
custom settings can be set while a cycle is in
progress.
To store a My Cycle combination of settings:
1. Select your drying cycle.
2. Change Temp and Level settings to fit your
needs.
NOTE: Sensor dry Level only works with
Cottons, Normal, Active Wear, Delicates,
Speed Dry, Bulky, Towels/Sheets, Sanitize
and Steam Dewrinkle cycles.
3. Select any drying options you want.
4. Press and hold the My Cycle button for 3
seconds to store your selection. A beep will
sound and the button will light up.
To recall your stored My Cycle combination:
Press the MY CYCLE button before drying a
load.
To change your stored My Cycle combination:
Repeat steps 1–4.